The maintenance of non-standard automation equipment helps to extend the service life of non-standard equipment, and allows the equipment to be used more accurately. Let's take a look at the maintenance requirements of non-standard automation equipment.

First, when the machine installs, disassembles and adjusts the reversing mechanism, attention should be paid to ensure that the center line of the non-standard automation equipment is parallel to the center line of the gear at the beginning, and the appropriate angle should be aligned to ensure that the machine does a good job at work.

Second, our equipment should always check the maintenance and connection status of each part, and if it is loose, it should be tightened. The body connecting bolts should be checked for tightness when the body is under pressure. All connecting shafts must have cotter pins and must be fully opened. Gradually stabilize the main components.

Third, often replace the parts that are easy to wear. If there is a fault, we need to eliminate the fault and then continue to operate. The motor bearing lubrication should be excellent. Always check all wires and cables for damage. To be promptly bandaged and replaced with some damaged. Useful for extended machine maintenance.

There is an automatic counting function in the production process of the fully automatic pin insertion machine. In addition to straight PIN pins, this machine can also bend PINs at 90 degrees (ie, insert "L" PINs). This machine is widely used in electronic transformer coil skeleton (plastic core), relay coil rubber core and other plastic or bakelite products for pin insertion.

1. The needle insertion speed of the machine is 50 pieces/min. After the needle is inserted, it is not necessary to use artificial needles. The output value of one machine in one day is equivalent to the total output value of more than 20 workers in one day.

2. The fully active pin insertion machine is professionally suitable for the pins of the pins of the LED dot matrix board and the circuit board of the LED digital tube.

3. The machine adopts PLC program control and man-machine interface operation.

4. After the machine is plugged in, the pins of the circuit board will not be like the products made by the skipping machine, and the needles will be de-tinned, and the surface of the needles will be oxidized and other defective products will occur.

5. The fully automatic pin insertion machine has fast pin insertion speed and high production capacity. Machine cost recovery time is short. After the capital is recovered, the production of the machine will greatly save the labor cost of your company.