The automatic feeder is a commonly used machine in the stamping industry for conveying coil materials. It is often installed on one side of the punch. The height of the feeding line of the automatic feeder is a value corresponding to the height of the die line used by the punch. Generally, after the punching press replaces the mold, the height of the mold line will change, so it is necessary to adjust the height of the feeding line of the automatic feeder.

However, many customers still have questions about the height of the feeding line of the automatic feeder, generally the following problems.

1. Is it possible not to adjust the height of the feeding line of the automatic feeder?

Answer: The height of the die line corresponding to different dies is different. If the height of the feeding line of the automatic feeder is not adjusted after the die is replaced by the punch press, it will lead to inaccurate feeding during the stamping operation, resulting in scratches and defects in the stamped product. The phenomenon of the product may cause serious damage to the mold and the automatic feeder.

2. Can all automatic feeders adjust the height of the feeding line?

A: All automatic feeders can. No matter it is air feeder, high-speed roller feeder, NC servo feeder, high-speed servo feeder, and three-in-one feeder, they all have feeding line adjustment functions, which are used to adjust with different molds.

3. How to adjust the feeding height of the automatic feeder?

Adjustment method:

 ① Install the punch die before adjustment

 ②Adjust the height of the feeding line of the automatic feeder according to the height of the mold, so that the height of the feeding line of the automatic feeder is slightly lower than that of the lower mold of the mold, but the height cannot be higher than the height of the lower mold of the mold.

  ③ Then place the mounting plate (or rack).

In addition, many operators at the customer site like to introduce the material into the mold guide column by feeding after the mold is installed, and then adjust the feeding height of the automatic feeder according to the material. This is a wrong adjustment method. This will cause the height of the feeding line of the automatic feeder to be higher than the height of the mold line of the mold, resulting in problems such as inaccurate feeding, so the height of the feeding line of the automatic feeder needs to be adjusted by professionals.